Skip to content
Tankless Costs Guide

Tankless Water Heater Problems and Error Codes: What They Mean

Updated November 2026

Short answer: most tankless error codes point to one of four things: the heater could not light, the flame went out, the air supply or vent is blocked, or scale has built up. You can safely check that the gas and water are on, that vents and filters are clear, and that the unit has power. Anything involving gas or electrical parts is a job for a technician.

Homeowner checking the display on a tankless water heater control panel

Safety first: if you smell gas, leave the building and call your gas supplier from outside. Do not try to reset the heater.

Rinnai error codes

CodeMeaningWhat to check
10Air supply or exhaust blockageIs the vent or air intake blocked?
11No ignitionIs the gas on? Is the tank empty (propane)?
12Flame failureGas supply, then call a technician if it returns
79Water leakage detectedTurn off the water and call a technician
LCLime scale build-upThe heater needs flushing
Source: Rinnai error code table, as reproduced by InspectApedia. Codes can vary by model, so check your manual.

A Rinnai manual notes that codes 11 and 12 usually indicate a gas supply problem, and that they can be cleared by stopping the water flow for a few seconds and starting it again. If the code comes back, the same manual says to use an authorised service centre.

Navien error codes

CodeMeaningWhat to check
E003Ignition failureIs the main gas supply valve open?
E004False flame detectionIs the power cord properly grounded?
E012Flame lossGrounding, and whether the intake air filter is clean
E016Heat exchanger overheatingClean the cold-water inlet filter; the unit may need flushing
E030Abnormal exhaust temperatureCall a technician
Source: Navien user manuals. Codes can vary by model, so check your manual.

Common problems without a code

  • Water goes cold, then hot again. Often called a cold water sandwich. It happens when taps are turned off and on in quick succession. A recirculation system can reduce it.
  • Not enough hot water with several taps running. The heater may be undersized for the demand, especially with cold incoming water. See the sizing guide.
  • Hot water takes a long time to arrive. This is usually the length of pipe between heater and tap, not a fault.
  • Flow or temperature has dropped over time. Scale or a clogged inlet filter is a common cause. See maintenance and flushing.

What a fix might cost

Water heater repairs typically cost $150 to $500, and a professional flush costs $150 to $350. See repair costs for more, or use the calculator, choose “Repair my tankless heater” and request quotes from local pros.

Sources: Rinnai error code table (via InspectApedia); Rinnai and Navien user manuals; HomeGuide and This Old House for costs. The “problems without a code” section is general guidance, not from these sources. Last checked November 2026. How we make money. Related: Rinnai costs, Navien costs, compare models, all guides.