Short answer: most tankless error codes point to one of four things: the heater could not light, the flame went out, the air supply or vent is blocked, or scale has built up. You can safely check that the gas and water are on, that vents and filters are clear, and that the unit has power. Anything involving gas or electrical parts is a job for a technician.

Safety first: if you smell gas, leave the building and call your gas supplier from outside. Do not try to reset the heater.
Rinnai error codes
| Code | Meaning | What to check |
|---|---|---|
| 10 | Air supply or exhaust blockage | Is the vent or air intake blocked? |
| 11 | No ignition | Is the gas on? Is the tank empty (propane)? |
| 12 | Flame failure | Gas supply, then call a technician if it returns |
| 79 | Water leakage detected | Turn off the water and call a technician |
| LC | Lime scale build-up | The heater needs flushing |
A Rinnai manual notes that codes 11 and 12 usually indicate a gas supply problem, and that they can be cleared by stopping the water flow for a few seconds and starting it again. If the code comes back, the same manual says to use an authorised service centre.
Navien error codes
| Code | Meaning | What to check |
|---|---|---|
| E003 | Ignition failure | Is the main gas supply valve open? |
| E004 | False flame detection | Is the power cord properly grounded? |
| E012 | Flame loss | Grounding, and whether the intake air filter is clean |
| E016 | Heat exchanger overheating | Clean the cold-water inlet filter; the unit may need flushing |
| E030 | Abnormal exhaust temperature | Call a technician |
Common problems without a code
- Water goes cold, then hot again. Often called a cold water sandwich. It happens when taps are turned off and on in quick succession. A recirculation system can reduce it.
- Not enough hot water with several taps running. The heater may be undersized for the demand, especially with cold incoming water. See the sizing guide.
- Hot water takes a long time to arrive. This is usually the length of pipe between heater and tap, not a fault.
- Flow or temperature has dropped over time. Scale or a clogged inlet filter is a common cause. See maintenance and flushing.
What a fix might cost
Water heater repairs typically cost $150 to $500, and a professional flush costs $150 to $350. See repair costs for more, or use the calculator, choose “Repair my tankless heater” and request quotes from local pros.
Sources: Rinnai error code table (via InspectApedia); Rinnai and Navien user manuals; HomeGuide and This Old House for costs. The “problems without a code” section is general guidance, not from these sources. Last checked November 2026. How we make money. Related: Rinnai costs, Navien costs, compare models, all guides.